Product Overview (Rear Panel); Operating Instructions; Setup; Setting Up The System - Nicols C 1216 Manuel D'utilisation

User manual
2.4 Product Overview (rear)

3. OPERATING INSTRUCTIONS

3.1 Setup

3.1.1 SETTING UP THE SYSTEM

1) Plug the AC to DC power supply to the system back panel and to the mains outlet.
2) Plug in your DMX cable(s) to your intelligent lighting as described in the fixtures respective manual.
For a quick Primer on DMX see the"DMX Primer" section in the Appendix of this manual.

3.1.2 FIXTURE ADDRESSING

The ideal way is to save 16 channels for each fixture (scanner). Makes Addr on fixtures to be 1, 17, 33, ...

3.1.3 RESETTING THE SYSTEM

Warning: This will reset the controller to its factory defaults.
This will erase all programs and settings.
Action :
1) Keep controller On and keep pushed PROGRAM + BANK DOWN buttons
2) Cut the power before to release both buttons at the same time
3) Switch the controller back On

3.1.4 COPY SCANNER

Example: Copying Scanner 1 into Scanner 2
Action :
1) Press and keep pushed SCANNER button # 1.
2) While holding button # 1 press SCANNER button # 2.
3) Release SCANNER button # 1 first before releasingSCANNER button # 2.
4) All SCANNER LED indicators will flash to confirm successful copy.
C 1216
22