Chase Programming; Create A Chase; Running A Chase; Checking A Chase - Nicols C 1216 Manuel D'utilisation

User manual

3.3 Chase Programming

A chase is created by using previously created scenes. Scenes become steps in a chase and can be arranged
in any order you choose. It is highly recommended that prior to programming chases for the first time; you
delete all chases from memory.
See" Delete All Chases" for instructions.

3.3.1 CREATE A CHASE

A Chase can contain 240 scenes as steps. The term steps and scenes are used interchangeably.
Action :
1) Press the PROGRAM button until the LED blinks.
2) Press the CHASE (1~6) button you wish to program.
3) Change BANK if necessary to locate a scene.
4) Select the SCENE to insert.
5) Tap the ADD button to store.
6) Repeat steps 3 ~ 5 to add additional steps in the chase. Up to 240 steps can be recorded.
7) Press and hold the PROGRAM button to save the chase.

3.3.2 RUNNING A CHASE

Action :
1) Press a CHASE button then press the AUTO DELbutton.
2) Adjust the Chase speed by tapping the TAP SYNC DISPLAY button twice at a rate of your choosing.

3.3.3 CHECKING A CHASE

Action :
1) Press and hold the PROGRAM button until the LEDis light.
2) Select the desired CHASE button.
3) Press the TAP SYNC DISPLAY button to switch the LED display to steps.
4) Review each scene/step individually by using the BANK UP/DOWN buttons.
3.3.4 EDIT CHASE
Action :
1) Press and hold the PROGRAM button to enter programming mode.
2) Press the desired CHASE button.
3) Select the BANK to be copied using the BANK UP/DOWN buttons.
4) Press MUSIC/BANK COPY button to prepare copy.
5) Press ADD button to copy the bank. All LEDs will blink
3.4.5 EDIT CHASE
Action :
1) Press and hold the PROGRAM button to enter programming mode.
2) Press the desired CHASE button.
3) Select the BANK that contains the scene to be copied using the BANK UP/DOWN buttons.
4) Press the SCENE button that corresponds to the scene to be copied.
5) Press MIDI/ADD button to copy the scene.
All LEDs will blink.
C 1216
25