Programming; Create / Modify A Scene - Nicols C 1216 Manuel D'utilisation

User manual

3.2 Programming

A program (bank) is a sequence of different scenes (or steps) that will be called up one after another. In the
controller 30 programs can be created of 8 scenes in each
3.2.1 CREATE A SCENE :
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the controller
and each bank can hold 8 scene memories. The controller can save 240 scenes total
Action :
1) Keep pushed the PROGRAM button until the LED blinks.
2) Choose a bank (01~30)
3) Select the SCANNERS you wish to include in your scene.
4) Compose a your scene by setting values for each channels using faders.
5) Keep pushed ADD and Tap MIDI/REC button, then release ADD
6) Repeat steps 2 through 5 as necessary. 8 scenes can be recorded in a Program.
7) To exit program mode, hold the PROGRAM button.
Deselect Blackout if LED is lit.
You can select more than one fixture.
There are 8 scenes available in every bank.
All LEDs will flash to confirm. The LED display will now indicate the Scene number and Bank
number used.
3.2.2 REVIEW SCENE ORCHASE
This instruction assumes that you have already recorded scenes and chases on the controller. Other wise
skip section and go to programming.
Action : (SCENE Review)
1) Select any one of the 30 banks by pressing theBANK UP/DOWN buttons.
2) Select a SCENE button (1~8) to review.
3) Move wheel and faders to change fixture attributes.
Action : (CHASE Review)
1) Press any one of the 6 CHASE buttons.
2) Press the TAP DISPLAY button to view the step number on the display.
3) Press the BANK UP/DOWN buttons review all scenes in the chase.
Make sure you are still in MANUAL Mode.
C 1216
23