Setting The Auto Surround Mode - Denon AVR-1604 Mode D'emploi

ENGLISH

Setting the Auto Surround Mode

For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
Setting the Ext. In SW Level
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1
After setting up the system
1
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other components
or speakers are connected to or the speaker layout is changed.
26
Use the (left) and (right) buttons to select the Auto Surround mode.
19 AUTOSURR. ON
Press the ENTER or (down) button to switch the Ext. In SW Level setting.
Use the (left) and (right) buttons to select the Ext. In Subwoofer channel Level playback.
20 EXT.IN SW +15
Press the ENTER or (down) button if you want to start the settings over from the beginning.
Press the SYSTEM SETUP button to finish system set up.
Default Auto Surround Mode
STEREO
II
Dolby PL Cinema
Dolby or DTS Surround
(Initial)
ON OFF
(left) button (right) button
+10
+00 +05
(left) button (right) button
(Initial)
+15