Denon AVR-1604 Mode D'emploi page 34

ENGLISH
3 Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
To select the surround mode while adjusting
the surround parameters, tone defeat or
tone control, press the surround mode
button then operate the selector.
4 Start playback on the selected component.
• For operating instructions, refer to the component's manual.
5 Adjust the volume.
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 37, if the volume for any channel is set at +1 dB
or greater, the volume cannot be adjusted up to 18 dB. (In this case
the maximum volume is adjusted to "18 dB — (Maximum value of
channel level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
After starting playback
[1] Adjusting the sound quality (tone)
1 The tone switches as follows each time the TONE CONTROL
button is pressed.
(Main unit)
2 With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control
counterclockwise. (The bass or treble sound can be
decreased to up to –12 dB in steps of 2 dB.)
34
(Main unit) (Remote control unit)
(Main unit)
(Main unit) (Remote control unit)
BASS TREBLE
(Main unit)
Input mode display
• In the AUTO mode
INPUT
AUTO DTS
PCM
• In the DIGITAL PCM mode
INPUT
AUTO PCM DTS
• In the DIGITAL DTS mode
INPUT
AUTO PCM DTS
• In the ANALOG mode
INPUT
AUTO PCM DTS
Input signal display
• DOLBY DIGITAL
SIGNAL
DIGITAL
• DTS
SIGNAL
DIGITAL
• PCM
SIGNAL
DIGITAL
The DIGITAL indicator lights when digital signals are being input
DIGITAL
properly. If the indicator does not light, check whether
the digital input component setup (page 25) and connections are
correct and whether the component's power is turned on.
NOTE:
• The DIGITAL indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
3 If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
(Main unit)
One of these lights, depending on the
input signal.
DIGITAL ANALOG
DIGITAL
DIGITAL
ANALOG
2 3 1
The signals do not pass through the
bass and treble adjustment circuits,
so it provides higher quality sound.