Denon AVR-1604 Mode D'emploi page 19

4
NOTE:
• When "Small" has been selected for the surround speakers, "Large" cannot be selected for the surround back speakers.
5
• Parameters
Large...... Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small...... Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume. When this setting is
selected, low frequencies of below 80 Hz are assigned to the subwoofer.
None...... Select this when no speakers are installed.
Yes/No.... Select "Yes" when a subwoofer is installed, "No" when it's not installed.
NOTE:
Select "Large" or "Small" not according to the physical size of the speaker, but according to the bass reproduction capacity at 80 Hz. If you cannot
determine the best setting, try comparing the sound when set to "Small" and when set to "Large", at a level that will not damage the speakers.
Caution:
In case the subwoofer is not used, be sure to set "Subwoofer = No", or the bass sound of front channel is divided to subwoofer channel and
not reproduced in some mode.
Use the (left) and (right) buttons to select your surround back speaker type.
4 S.BACK
Press the ENTER or (down) button to switch to the subwoofer setting.
Use the (left) and (right) buttons to select your subwoofer setting.
5 S.WOOFER
Press the ENTER or (down) button to enter the settings and switch to the subwoofer mode setting.
(Initial)
LARGE SMALL
SMALL
(left) button
(Initial)
YES
YES
(left) button
ENGLISH
NONE
(right) button
NO
(right) button
19