Introduction; Equipment - ESAB Origo Mig 410 Manuel D'instructions

US
This product is solely intended for arc welding. Any other use may result in personal
injury and / or equipment damage.
Read and understand the instruction manual
before installing or operating.
ESAB can provide you with all necessary welding protection and accessories.
3

INTRODUCTION

The Mig 410 and Mig 510 are step-controlled power sources designed for
MIG/MAG-welding together with wire feed units Feed 302, 304, 484 and
YardFeed 200.
The power sources are fan-cooled and equipped with thermal overload protection.
ESAB's accessories for the product can be found on page 55.
3.1

Equipment

The power source is supplied with:
S
5m return cable with return clamp
S
Shelf for gas cylinder
S
Guide pin for wire feed unit
S
Instruction manual
ba58ae
- 8 -
© ESAB AB 2011