Error Codes; Inductance Settings (Fe/Ss) - ESAB Caddy Mig C200i Manuel D'instructions

US
5.3

Error codes

If an error occurs, only the error code will be visible.
Error No. Description
1 Program related error
2 Hardware related error
3 Hardware related error
5 Program related error
4 Thermal protection
5.4

Inductance settings (Fe/SS)

In certain cases especially for mild steel welding in different gases the quality of
welding may be improved by changing the inductance settings of the power source.
The inductance function is normally hidden, but can be invoked by the pressing and
keeping pressed the pushbutton (H) for 5s or more. When this setting is available,
all graphics from the right side of the display disappears, and only number from 00 to
10 is displayed. This number corresponds to the inductance value. 00 means that
the inductance is low and the welding arc is "sharp", 10 means that the inductance is
high and the welding arc is "soft".
The value of the inductance can be set by means of the knob (I). Default setting is
05.
Recommendations:
S
When the CO is used it is recommended to set lower inductance then 05, for
2
instance from 03 down to 00.
S
When the Ar/CO
from 05 up to 10.
The display goes back to the regular appearance 10s after the last movement of the
knob (I) or pressing pushbutton (H). The return to the regular mode can accelerate
by again pressing and keeping the pushbutton (H) pressed for 5s.
bc22a
Action
Switch the machine OFF, wait 30 sec. and switch it ON.
Call for service if the error
remains.
Do not switch the power source OFF, let it to cool down.
mixture is used, the operator should set higher inductance
2
- 18 -