Marking kits and testing devices
A) Marking kits
Standard kit
No: 54-B 080
• 1 marking wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M,
100 ml solution
• 1 SURFOX-E,
100 ml solution
The standard kit requires the use of permanent stencils.
* Also available, SURFOX-M 5 L to refill the squeeze
bottles. No: 54-A 036
B)
SURFOX testing devices
SURFOX Smart Passivation Tester
(54-T 011)
To monitor the state of
corrosion protection and
to ensure proper passiv-
ation of the workpiece.
Corrosion resistance of
stainless steel is signifi-
cantly reduced near
welds as a result of the heating cycle. Visually,
this can be seen as a darkened zone next to the
weld. When electro-chemical cleaning is performed
on the weld, corrosion risk is reduced but the
treated zone still has to be passivated for 24-48
hours before the corrosion protection is fully
restored.
PRO kit
No: 54-B 081
• 1 marking wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M,
100 ml solution
• 1 Stencil printer and software
• 1 Stencil paper roll 100 mm (W) X 20 m (L)
The PRO kit is offered with a stencil thermo printer for the
printing of disposable stencils to permanently mark stainless
steel surfaces. The printer comes with software that allows
the creation of stencils for barcodes, serial numbers, lot
and batch numbers, text, company logos, and more.
Stainless steel grade
Identification tester
No: 54-T 001
There are countless
types of stainless steels,
mainly grouped in 3
categories or grades:
200, 300 and 400.
Since it is visually impossible
to differentiate between
200, 304, 316 and 400 grade stainless steel, WALTER
provides a test kit that allows customers to instantly
identify the grade of stainless steel.
Product description
Testing device
◆
Molybdenum reagent, 100 ml
◆
Blotting paper
◆
9
Marking kits and testing devices
User's Guide SURFOX MINI
13