Equipment Controls; Control Panel Pictograms - Walter Surface Technologies MINI SURFOX Manuel De L'utilisateur

Masquer les pouces

Table des Matières

Les langues disponibles

Safety instructions

Amperage

Before connecting this unit, check that the amperage

shown on the rating plate is the same as the power supply.

Operating this unit on an amperage other than

its rating plate may result in personal injury to the user and

damage the unit.

Preventive maintenance

After use, allow the tip to cool and remove the cleaning pad.

Neutralize with SURFOX-N and rinse the cleaning pad and

wand tip with water and dry. Clean dust and dirt deposits

from the exterior of the unit. Keep all

free of any obstructions. Clean the power cord to prevent

deterioration and check for possible damage to cord and

plug.

Note: Damaged cords must be replaced immediately by

personnel only. Refer to Spare Parts List for the

ordering number.

Transportation

Before transporting the machine, remove the electrolyte

solution cartridge and make sure all connecting lines are

disconnected. The machine must be carefully packed in a

suitable container and properly protected. WALTER will

not be held responsible for any damages resulting from

leaked cleaning solution or rough handling.

Storage

If the machine is to be stored for any length of time, the

solution cartridge and cleaning pad must be removed

(neutralized, rinsed and left off) and the insert neutralized,

rinsed and dried. Store in a dry safe place to avoid damage,

especially to the electronic components.

Waste disposal

Dispose of residual waste in compliance with Federal,

Provincial, State and local environmental regulations. Refer

to WALTER Material Safety Data Sheet of the SURFOX

electrolyte cleaning solutions.

Extension cord

When an extension cord is needed, use wire size 14 (AWG)

for up to 50 feet (15 meters) and size 12 (AWG) for 50 to

100 feet (15 to 30 meters).