Front View Of The Machine - Walter Surface Technologies MINI SURFOX Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5

Front view of the machine

Front view of the machine
Power selector
Power cable connector for
cleaning wand and optional
marking wand
ELECTROCHEMICAL CLEANING: Select this setting
when using the mini wand attached to the SURFOX unit.
Select AC and 1, 2 or 3 depending on the amount of
heat tint to remove and the type of material that is
being cleaned.
ELECTROCHEMICAL POLISHING: This mode is
used for cleaning, passivating and polishing the weld.
The cleaning and passivating process takes longer in
the DC mode than in the AC mode. DC mode is used to
polish the weld bead to match the surface of the finish.
Select DC and 1, 2 or 3. Stainless Steel only.
8
ON/OFF button
Application selector
Ground connector
ELECTROCHEMICAL MARKING: Select this setting
when using a marking/etching wand which has been
plugged into the power cable connector. Select AC
mode and 1, 2 or 3 for stainless steel, aluminum and
titanium. Use SURFOX-M for Stainless Steel and
Titanium; SURFOX-M ALU for Aluminum.
ELECTROCHEMICAL ETCHING: Select this setting
when using a marking/etching wand which has been
plugged into the power cable connector. Select DC
mode and 1, 2 or 3. Stainless steel and Aluminum only.
Use SURFOX-E.

Publicité

Table des Matières
loading

Table des Matières