Using The Marking Wand (Optional); Marking Kits; Surfox Testing Devices - Walter Surface Technologies SURFOX 104 Manuel De L'utilisateur

8

Using the marking wand (optional)

Using the marking wand (optional)
A) Marking kits
Standard kit (54-B 080) includes:
• 1 marking wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M, 100 ml
solution
B) SURFOX testing devices
Stainless steel Passivation Testing Device
(54-T 010)
reduced near welds as a result of the heating cycle. Visu-
ally, this can be seen as a darkened zone next to the weld.
When electro-chemical cleaning is performed on the weld,
corrosion risk is reduced but the treated zone still has to be
passivated for 24-48 hours before the corrosion protection
is fully restored.
TECHNICAL BULLETINS AvAILABLE ON OUR WEB SITE.
10
To monitor the state of corro-
sion protection and to ensure
proper passivation of the
workpiece.
Corrosion resistance of
stainless steel is significantly
PRO kit (54-B 081) includes:
• 1 marking wand with
graphite insert
• 35 mm X 10 mm
and connecting cable
• 20 marking pads
• 5 O-Rings
• 1 SURFOX-M, 100 ml solution
• 1 stencil printer and software
• 1 stencil paper roll
100 mm (W) X 20 m (L)
Stainless steel Grade
Identification Testing
Device (54-T 001)
Informs you on the type of
stainless steel you are really
working with.
Because it is visually impos-
sible to differentiate 200,
300 and 400 grade stainless
steel, the testing device
instantly identifies the grade
of stainless steel.