Drip Stop; Brewing Coffee - Ninja Coffee Bar CF097 Série Guide D'utilisation

CAUTION: HOT WATER. Do not remove the brew basket or vessel while brewing.
CAUTION: STEAM. Do not touch steam vents or the top of the brewer while brewing.
CAUTION: The brew basket is hot after brewing. Always allow the brewer to cool down before cleaning.
Fig. 17

DRIP STOP

NOTE: If the Drip Stop is closed before you begin a
brew, the brewer will notify you with 5 beeps and
the Drip Stop light will be illuminated. Set the Drip
Stop to the open position and select your brew
concentration level.
CAN'T WAIT FOR THAT FIRST CUP TO BE READY?
When brewing a carafe, close the Drip Stop to pause the
brew cycle and pour a cup. Remember to reopen the Drip
Stop to complete the brew. (Fig. 17)
NOTE: If you forget to open the Drip Stop, the Ninja Coffee
Bar will pause the brew, and after 20 seconds it will give
®
you a friendly audible reminder. After 6 minutes the brew
will be canceled.
CAN'T WAIT FOR THE LAST FEW DROPS?
When the brew cycle is complete, set the Drip Stop to the
closed position to stop dripping from the brew basket.
NOTE: While the Drip Stop is closed, the Drip Stop indicator
will light up in the bottom right hand corner of the control
panel.
NOTE: Remember to open the Drip Stop when you're ready
to brew again. If you forget, your Ninja Coffee Bar will give
you a friendly audible reminder.

BREWING COFFEE

NOTE: Each brew has a pre-infusion cycle with
varying times. The brew will begin, stop, and be
quiet for a short period of time before it begins
again. This process is used to evenly saturate your
coffee grounds.
NOTE: For a hotter coffee, rinse the coffee cup, mug or
thermal carafe with hot water prior to brewing.
CAUTION: Ensure the coffee cup, mug or thermal
carafe is completely empty before starting a brewing
cycle. Starting a brewing cycle with coffee in the
vessel will cause an overflow.
Fig. 18
CUSTOM BREWS: CLASSIC, RICH OR OVER ICE BREW
Classic Brew - For a smooth, balanced flavor.
Rich Brew - For a coffee that is richer than Classic
Brew and still smooth, with more room for milk and
cream.
1
After filling the water reservoir and adding ground
coffee to the filter, be sure that the Drip Stop is open
and the reservoir, basket, and filter are securely in
place.
2
Use the Multi-Serve dial to select the size of coffee you
would like to brew. Place the empty vessel that you
would like to brew into underneath the brew basket.
NOTE: If making a single cup, lower the Multi-Serve
Cup Platform down and center the cup or mug on the
platform. Please ensure that you are using at least a 12
oz. cup for the Cup size, 14 oz. cup for the XL Cup size,
16 oz. travel mug for the Travel Mug size and 20 oz.
travel mug for the XL Multi-Serve size.
3
Press the CLASSIC BREW or the RICH BREW button
and the brew will begin. (Fig. 18, Fig. 19) Press the
CLASSIC BREW or RICH BREW button again to cancel
the brew.
NOTE: The brew will begin, stop, and be quiet for
a short period of time before it begins again. This
process is used to evenly saturate your coffee
grounds.
NOTE: Do not remove water reservoir, brew basket, or
vessel while brewing.
4 The Ninja Coffee Bar will beep to signal a completed
brew.
NOTE: Rich Brew will use slightly less water and yield
slightly less brewed coffee than Classic Brew.
Fig. 19
ninjakitchen.com
14