Drip Stop; Intelligent Warming Plate; Stay Warm Button - Ninja COFFEE BAR CF082 Manuel Du Propriétaire

CAUTION: HOT WATER Do not remove the brew basket or vessel while brewing.
CAUTION: STEAM Do not touch steam vents or the top of the brewer while brewing.
CAUTION: The brew basket is hot after brewing. Always allow the brewer to cool down before cleaning.
Fig. 16

DRIP STOP

NOTE: If the Drip Stop is closed before you begin a
brew, the brewer will notify you with 5 beeps. Set the
Drip Stop to the open position and select your brew
concentration level.
CAN'T WAIT FOR THAT FIRST CUP TO BE READY?
When brewing a carafe, close the Drip Stop to pause the
brew cycle and pour a cup. Remember to reopen the Drip
Stop to complete the brew. (Fig. 16)
NOTE: If you forget to open the Drip Stop, the Ninja Coffee
Bar will pause the brew, and after 20 seconds it will give
™
you a friendly audible reminder. After 6 minutes the brew
will be canceled.
CAN'T WAIT FOR THE LAST FEW DROPS?
When the brew cycle is complete, set the Drip Stop to the
closed position to stop dripping from the brew basket.
NOTE: While the Drip Stop is closed the Drip Stop indicator
will light up in the bottom right hand corner of the control
panel.
NOTE: Remember to open the Drip Stop when you're ready
to brew again. If you forget, your Ninja Coffee Bar
you a friendly audible reminder.
Fig. 17

INTELLIGENT WARMING PLATE

The Intelligent Warming Plate will automatically turn on after
a Classic or Rich on Carafe or Half Carafe. The Intelligent
Warming Plate will adjust the heat it produces in order to
avoid burning the coffee over time.
CAUTION: The HOT SURFACE light will illuminate
when the warming plate is hot. Do not touch the
surface when this light is illuminated.

STAY WARM BUTTON

Press the Stay Warm Button after the brew to turn the
Intelligent Warming Plate off. You can turn the Intelligent
Warming Plate back on within 2 hours of the brew by
pressing the stay warm button again if desired. (Fig. 17)
If you would like the Warming Plate to stay on longer, you
can program it to stay on up to 4 hours.
1
Turn the Multi-Serve dial to half carafe or full carafe.
2
Press and hold Stay Warm until the clock begins to
flash the current time the warming plate will stay on for.
3
Quickly press the hour or minute (H or M) to increase
the time up to 4 hours.
will give
™
4
The time will lock in after 5 seconds or you can press
the Stay Warm button.
AM
H
PM
M
DELAY BREW
STAY WARM
TRAVEL
HALF
CUP
FULL
CLA SSIC BRE
W
RICH BRE W
OVE R ICE BRE
W
SPEC IALTY
BREW
(CONCE NTRATE
D COFFEE )
CLEAN
DRIP STOP
www.ninjacoffeebar.com
20