Discs For Recording - Pioneer DVD-R7322 Mode D'emploi

SAFETY INSTRUCTIONS
Disc-related
Recommended Discs
For stable recording and playback,
always use a recommended brand of
disc.
For specific disc recommendations,
consult your dealer or the Pioneer
website.
Avoid touching or scratching the signal
surface (shiny side) of the disc
Hold the disc by the edges or by the
center hold and one edge
Do not affix paper or labels to the disc
Discard warped or
cracked discs as
they may cause
damage to the
drive
Avoid specially
shaped discs such
as hearts or
polygons
Remove dust or
lint from the disc
with a soft cloth
by wiping from
the inside to the
outside edge rather than in a circular
motion
Do not use record-cleaning or anti-static
agents as the solutions may cause
damage to a disc
INSTALLATION-RELATED PRECAUTION
Be sure to remember the following points during the installation of your DVD-R7322.
A maximum of four DVD-R7322s can be connected to the "DRM-7000" 700-disc
changer.
The DVD-R7322 may not be used together in conjunction with a "DRM-PW701"
power supply unit.
This drive may be installed in drive vays 1 to 8.
6
En

Discs for Recording

When data cannot be recorded or
errors occur during recording:
Are you using a recommended brand
of disc?
Has a sufficiently large writing area
been secured?
Are you using a disc that has already
been finalized (closed to further
recording)?
Has the disc been inserted correctly
with its label side facing up and writing
side down?
Is the disc dirty or scratched?
The device cannot read a disc that
has been recorded.
Are you using a recommended brand
of disc?
Is an unwritten disc installed?
Is the disc dirty or scratched?
It is possible that condensation has
formed on the optical components or
on the disc. (Wait 1 to 2 hours before
attempting to use the device again.)
* For other issues, consult the operating
instructions accompanying your
application software.