Waeco MagicWatch MWE850 Instructions De Montage Et De Service page 42

MWE-850-4DSM.book Seite 42 Mittwoch, 23. Mai 2007 4:35 16
Installing MWE850
6.5 Fastening the display
Note the following information when selecting a place to fit the display:
Note the length of the display cable.
Note that the boot cover swings upwards on vehicles that have a big tail-
gate.
The display must be easily visible when you are reversing.
The display must not be covered or damaged by any objects placed on
the boot cover.
Fit the display so that there is no danger of injury, for example when
sharply braking.
Its compact design means it can be fitted in many places in the vehicle.
Good positions at the front are (see fig. 14, page 7):
– Above the rear view mirror
– On the dashboard
– On the ceiling
– On the window beside the wing mirror
Good positions to the rear are (see fig. 15, page 8):
– On the boot cover
– On the ceiling
– Next to the window
– On the C pillar
➤ Pull off the protective foil and stick the display in a suitable position.
Note
The extension cables are marked: L (left) and R (right).
This marking helps you connect them to the control electronics to
ensure that the display is correct. These markings can also be
found on the control electronics.
The polarity of the socket cannot be reversed: They can be only
be plugged into the connection in one way.
➤ Insert the display plug into the socket of the corresponding extension
cable (see fig. 16 A, page 8).
➤ Guide the extension cable to the control electronics and insert the socket
of the extension cable into the connection on the control electronics (see
fig. 16 B, page 8).
42
MagicWatch MWE850