Detection Range - Waeco MagicWatch MWE850 Instructions De Montage Et De Service

MWE-850-4DSM.book Seite 36 Mittwoch, 23. Mai 2007 4:35 16
Technical description
Only use WAECO cables.
Otherwise, proper operation cannot be guaranteed.
Defective sensors can be replaced without removing the bumper. There is a
plug connector just behind the sensor for this.
5.2

Detection range

The detection range of MWE850 is divided into three zones (see fig. 5,
page 5):
Zone 1
This zone is the first limit range. Small or objects with poor reflective char-
acteristics are sometimes not detected in this zone.
Zone 2
Nearly all objects are displayed in this zone.
Zone 3
Nearly all objects are displayed in this zone, but some objects may come
into the blind spot of the sensors.
Situations may arise where MWE850 does not detect objects or
fails to signal their distance correctly, due to their physical charac-
teristics.
Note the four following examples.
Example 1 (see fig. 6, page 5)
Objects which do not enter the detection area of the sensors cannot be
recorded.
Example 2 (see fig. 7, page 5)
The distance to objects with large gaps in them may not be correctly sig-
nalled. In the example, A is not signalled, but only B or C instead.
Example 3 (see fig. 8, page 5)
For diagonal obstacles, the shortest distance A is signalled.
36
MagicWatch MWE850