15.5. Hot water for infusions
•
Place a recipient under the water tap, where you want to get the hot water.
•
Open the water knob,
•
Close the water knob when reached the desired volume of water.
16. Coffee machine with built-in grinder
1 BEAN HOPPER LID
2 BEAN HOPPER
3 BEAN HOPPER GATE
4 COFFEE GRINDING ADJUSTMENT DISK
5 GRINDING TRIGGER
6 GROUND COFFEE DOSAGE DEVICE LID
7 GROUND COFFEE DOSAGE DEVICE
8 GRINDER ON/OFF SWITCH
9 DOSAGE DEVICE LEVER
10 COFFEE TAMPER
11 GROUND COFFEE OUTLET
16.1. Previous operations before starting-up the coffee grinder:
a) Check that the bean hopper (2) is correctly fitted in place.
b) Place the bean hopper gate (3) in a locked position, in order to avoid the pass of the coffee beans to the
grinder, just pressing it.
c) Lift up the bean hopper lid (1), fill the bean hopper (1) with coffee beans and close it again.
d) Slide open the bean hopper gate (3) to the position that allows the coffee getting into the grinder.
16.2. How to obtain a grinded coffee dosage:
a) Place the porta filter under the grinded coffee outlet (11).
b) Pull from the ground coffee dosage device lever (9) towards you in order to obtain a dosage and release the
coffee dosage device lever free.
c) Place the porta filter under the coffee tamper (9) and push it upwards in order to compact the coffee.
16.3. Adjusting the grinding degree of coffee:
You can adjust the grinding degrees (thinner ground coffee/coarser ground coffee) as follows:
a) If you want to obtain thinner grinded coffee: Maintain pressed the millstone trigger (5)(models till 2009)
while turning right the setting grind wheel (4), then release the trigger.
b) If you want to obtain a coarser grinded coffee:. Maintain pressed the millstone trigger (5) (models till
2009) while turning left the setting grind wheel (4), then release the trigger.
16.4. Adjusting of the grinded coffee quantity per dosis:
a) Switch OFF the grinder general switch, (8).
b) Remove ground coffee dosage device lid (6).
•
In order to get lower dosage: Turn the coffee grinding adjustment disk
clockwise.
•
In order to get higher dosage: Turn the coffee grinding
adjustment disk counter clockwise.
c) Re-install the ground coffee dosage device lid (6) in place.
Note; as to measure 7 grs of grinded coffee you get a measuring spoon with the
machine.
If when brewing espresso, it comes out very fast, the grinder is set too coarse.
If when brewing espresso, it comes out very slow, the grinder is set too thin.
Espresso should come out with an slow, thin and continuous flow.
Coffee machine with built-in grinder
6
7
8
9
10
16
5
11
Lever
English
1
2
3
4