MAINTENANCE
Auxiliary light bulb
To replace the auxiliary light bulb, proceed same as to the previous points (1)
and (2) then:
1.
Pull out the cable with bulb holder (8)
2.
Pull out the position light bulb (9) by gently pulling it as shown.
3.
Install a new position light bulb, then proceed to re-assemble the parts in
reverse order to the dismantle, following partially common operations to
the headlight reassembling.
Headlight adjustment
For a quick check of the correct direction of the front light beams, place the
vehicle ten meters from a vertical wall and make sure the ground is level.
Turn on the low beam light "
light beam projected to the wall is slightly below horizontal straight line (about
9/10 of the total height).
To adjust the light beam:
•
Turn the knob [10] clockwise to raise the light beam
•
Turn the knob [10] counterclockwise to lower it.
76
", sit on the motorcycle and check that the