6.5 POWER SUPPLY:
•
Baby unit:
The baby unit can only be powered by the supplied power adapter.
The baby unit has no built-in battery for mobile use.
•
Parent unit:
The parent unit is powered by the rechargeable 3.7V Lithium-Ion battery; this
battery can power the parent unit for 6 to 7 hours.
In the upper right corner of the display, you can check the battery status:
: battery if full
: battery is only 2/3 full
: battery is only 1/3 full, please charge
: battery is empty and the parent unit will switch off
: battery full / no battery installed
The red indicator will start flashing on the display approximately 5 minutes
before the battery is completely empty. The unit also emits notification sounds.
Please immediately connect the adapter.
The battery can fully charge an empty battery in about 6 hours, regardless
whether the parent unit is switched on or off during this time.
6.6 INTERFERENCE-FREE:
•
This baby display monitor is digitally coded. This means you will never receive
signals from other devices, nor can the signal from your baby unit(s) be recei-
ved by e.g. your neighbors.
•
In case the baby unit(s) or parent unit is placed in or in the close vicinity of
electromagnetic fields, the signal (images or sound) can be slightly affected. If
this happens, try a different location for the baby unit(s) or parent unit or move,
if possible, the source of the interference.
6.7 RANGE:
The baby display monitor has a range of up to 300 meters in an open field and
•
up to 50 meters indoors; this range depends on local circumstances.
If the units get out of range from each other, the image will first 'freeze' for
•
several seconds (no movement), followed by ' ' (no reception) and then the
display will turn black.
6.8 EAVESDROPPING/WIRETAPPING:
•
Eavesdropping/wiretapping of the signals from this baby video monitor is near-
ly impossible. Not only must one be within range of the baby video monitor,
one also needs some very costly equipment.
: battery is charging
53