Installation; Baby Unit; Parent Unit - Alecto DVM-370 Mode D'emploi

3

INSTALLATION

3.1 BABY UNIT: (CAMERA)
The baby and parent units are not waterproof, therefore they are only
suitable for indoor use.
Power adapter:
1. Connect one of the included power adapters to the DC5.9V input on the side
of the baby unit.
2. Insert the adapter into a 230V wall socket.
Only use the supplied power adapter.
Make sure the baby cannot touch the baby unit or cable. Keep the baby unit at
least 2 meters away from the baby and bundle cables that are too long with tape
or cable ties specifically for this purpose.
Table model or wall model:
You can place the baby unit on a table, cabinet or desk or you can hang it on the
wall.
In case of wall mounting:
Drill a hole in the wall and insert plug and screw. The head of the screw should
stick out of the wall for several millimeters.
Suspend the baby unit by sliding the notch in the camera support over the screw
in the wall and pushing the baby unit a little downwards.
Finally, use cable clips to neatly tuck away the adapter cable.
Tips for placement:
• For use as a baby monitor: place the baby unit at least 2 meters away from your
baby and make sure to safely tuck away the adapter cable.
• For optimal range, it is advisable to set up the baby unit as high as possible, free
from large metal surfaces.

3.2 PARENT UNIT:

The parent unit is not waterproof and therefore only suitable for indoor use.
Power supply:
The parent unit can be powered directly by the included rechargeable battery or
via the supplied power adapter. As soon as you connect the power adapter, it will
charge the battery allowing for mobile use of the parent unit.
45