arimar CLASSIC 270 Manuel Du Propriétaire page 77

We recommend using a pressure gauge to check the pressure of your
boat. It must be 18 kPa (0,18 bar and approx. 180 cm of column of water)
in the every air chambers. The pressure fluctuates with changes in
temperature and increases after prolonged exposure to sunlight.
For instance, a 10 degree variation in the ambient temperature will cause
an increase or a decrease in the inner pressure of 3,18 kPa. The rated
pressure will go from 18 kPa to 21,8 kPa.
NOTE
Use of the pressure gauge:
a) Insert the pressure gauge into each valve, starting from grey valves.
b) The pressure gauge must be inserted when the boat is only partially
inflated.
c) Insert the pressure gauge into the valve to measure the pressure.
Then, inflate the boat further and measure the pressure again.
Go on until the proper pressure is reached.
CAUTION
DO NOT use air compressors or scuba tanks to inflate your boat.
CAUTION
The pressure of the boat fluctuates with changes in temperature.
Adjust the pressure by inflating and deflating the boat.
SEPTEMBER 2021
77