Product Components - HYDROLAB HL Série Manuel D'utilisation

The HL7 sonde has a temperature sensor, seven external sensor ports and an optional internal
depth sensor. The seven external sensor ports can include a maximum of seven different sensors or
six different sensors and the optional central cleaning brush.
Refer to the sensor settings screen of the Hydrolab Operating Software to identify the sensors
installed. All sensors are installed at the factory and are not user-replaceable without authorization
from the manufacturer.
Figure 1 Instrument overview—HL4 sonde
1 Calibration cap for the storage/calibration cup
2 Storage/Calibration cup
3 Sensors in clear pH 4 buffer
5
4 Locking screw (2x)
5 Housing
Figure 2 Instrument overview—HL7 sonde
1 Calibration cap for the storage/calibration cup
2 Storage/Calibration cup
3 Sensors in clear pH 4 buffer
4 Middle rubber bumper
5
5 Locking screw (3x)

Product components

Make sure that all components have been received. Refer to
missing or damaged, contact the manufacturer or a sales representative immediately.
4
The standard version is shown.
5
For manufacturer use only
6
Remove the middle bumpers and end bumpers as necessary to use the instrument in a narrow
space such as a well.
7
Units with an internal battery pack only
6 English
4
6
6 Middle rubber bumper (2x)
7
7 Battery compartment
8 End rubber bumper (2x)
9 Connector
10 Mooring cap
6 Housing
7 End rubber bumper (2x)
8 Connector
9 Mooring cap
Figure 3 or Figure
6
6
6
4. If any items are