weewell WMA370 Mode D'emploi page 12

from large obstructions such as walls and doors.
•Remove the batteries and then install it again. Turn on the baby unit and the parent
unit. Allow up to one minute for the parent unit and the baby unit to synchronise.
•Other electronic products may cause interference with your audio monitor. Try
installing your audio monitor as far away from these electronic devices as possible:
wireless routers, radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
Battery low at the Parent Unit.
•Charge the battery in the parent unit for up to 12 hours.
•The volume level of the parent unit may be set too high which consumes power.
Decrease the volume level of the parent unit. Refer to Adjust speaker volume (p. 8)
for volume level settings.
•Remove the battery and then install it again. Use it until fully depleted, then
recharge it in the parent unit for up to 12 hours.
•If the above measures do not correct the problem, replace the battery.
The battery does not charge in the parent unit or the parent unit battery does
not accept charge.
•Make sure the batteries are installed in the parent unit battery compartment
correctly. The Charging indicator light on the parent unit should be on when
charging.
•Remove the battery and then install it again, then charge for up to 12 hours.
•If the battery is completely depleted, it may take up to 30 minutes to charge the
parent unit before it can be used for a short time.
•Purchase new batteries. Refer to Parent unit battery installation and Parent unit
battery charging.
The parent unit beeps.
•Move the parent unit closer to the baby units (but not less than 1.5 metres). The
parent unit may be out of range.
•The batteries may be running low, Connect the parent unit to the mains power with
the supplied power adaptor for recharging.
•The baby unit may be switched off. Press and hold key to switch on the baby unit.
Common cure for electronic equipment.
•If the audio monitor is not responding normally, try the following (in the order
listed):
1.Disconnect the power to the baby unit and the parent unit.
2.Remove the batteries in the parent units and then install the batteries again.
12 I
WMA370 USER MANUAL