weewell WMA370 Mode D'emploi page 11

•Make sure the baby unit, parent unit and the batteries are installed and charged
correctly. For optimum daily performance, charge the parent unit when it is not in
use.
•Make sure the power adapters are securely plugged into the outlet not controlled by
a wall switch.
•Make sure the adapter cords are plugged fi mly into the baby unit and parent unit.
•Make sure the baby unit and the parent unit are turned on.
•The parent unit may be too far away from the baby unit. Move the parent unit closer
to the baby units (but not less than 1.5 metres).
•Unplug the electrical power to the baby unit and parent unit. Wait for approximately
15 seconds, then plug it back in. Turn on the baby unit and the parent unit. Allow up
to one minute for the baby unit and the parent unit to synchronise.
•Charge the batteries in the parent unit for up to 12 hours.
•If the parent unit batteries are completely depleted, they may take up to 30 minutes
to charge the parent unit before it can be used for a short time.
•Remove the batteries and then install them again. If that still does not work, it may
be necessary to purchase new batteries.
•Large obstructions may impact the reception. Try to relocate the baby unit, away
from large obstructions such as walls and doors.
•Other electronic products may cause interference with your audio monitor. Try
installing your audio monitor as far away from these electronic devices as possible:
wireless routers, radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
The audio monitor produces high-pitched noise.
•The parent unit may be too close to the baby unit. Make sure the parent unit and the
baby unit are at least 1.5 metres away from one another.
The parent unit plays any sounds from the baby unit and I think it is too noisy.
•You may need to adjust the speaker volume on the parent unit.
The parent unit does not play any sound when there is noise from the baby unit.
•Make sure the parent unit is powered up by connecting it to mains power or to the
rechargeable batteries provided.
•Make sure the parent unit is turned on and the speaker volume is not set to off.
•The parent unit may be too far away from the baby unit. Move the parent unit closer
to the baby unit (but not less than 1.5 metres).
•If the parent unit is powered by the provided batteries, make sure there is suffici t
charge. Charge the battery in the parent unit for up to 12 hours.
•Large obstructions may impact the reception. Try to relocate the baby unit, away
I 11
WMA370 USER MANUAL