Sanitising Function - Teuco VASCHE Manuel D'utilisation

EN
SAnITISInG FUnCTIOn (where featured)
SANITISING FUNCTION icon
GET OUT OF THE TUb icon
INSUFFICIENT SANITISER icon
INSUFFICIENT WATER icon
EMPTYING TUb icon
Teuco's SANITISING FUNCTION envisages the
automatic introduction of sanitising liquid into the
bathtub, after each time the product is used. The
user need only fill the dedicated tank periodically.
At the end of any of the water treatments (Whirlpool,
Sonic-massage, waterfall or blower), the bathtub
sanitising screen is displayed.
Activate the function
Sanitising starts by touching the related icon.
n.B.: Sanitising is not carried out if you
touch the POWER icon.
Get out of the tub
For the first 30 seconds, the system waits for the
user to get out of the bathtub. The function exploits
the water already in the tub, so the latter will not be
emptied. The GET OUT OF THE TUb icon flashes
the entire time.
Start sanitising
The sanitising function starts by activating the
whirlpool or waterfall or both for approximately 1
minute, during which time the sanitising liquid is
introduced automatically.
Wait
At the end of the whirlpool, the water and sanitising
liquid must remain in contact with the surfaces and
product components for 10 minutes. A timer counts
down the wait time.
32
30"
10'