Faults - Teuco VASCHE Manuel D'utilisation

FAULTS

The faults are shown at the start of function
activation. They provide information about the
problem that has arisen. We recommend you
check the meaning on the manual and notify an
authorised Teuco Technical Service Centre if the
fault persists or the product is malfunctioning.
When the fault is signalled, first of all perform a
system RESET as follows:
1. unplug the appliance
2. power it back on after a few seconds
3. run the function that had been blocked by the
fault again.
If the fault persists, contact an authorised Teuco
Technical Service Centre.
The table below lists some of the possible faults
that may be encountered in the system:
CODE FAULT DESCRIPTIOn
E01
UP HYDRO communication error
E02
CROMO communication error
E05
Temperature probe error
E07
UP HYDRO fuse error
E09
UP SONIC communication error
E11
UP HYDRO thermostat error
E12
UP HYDRO thermic error
E20
UP SONIC ultrasound head error
Esempio schermata di segnalazione errore
E21
UP SONIC temperature error
E23
bLOWER communication error
E26
UP SONIC ballast error
E36
INVERTER communication error
E37
UP INVERTER NO load error
E38
UP INVERTER short-circuit error
E39
UP INVERTER overload error
E40
UP INVERTER overheating error
E41
UP INVERTER over-voltage error
EN
37