Consumables - Hilti AG 500-A18 Mode D'emploi

3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system prevents the power tool overheating by monitoring current input
and motor temperature.
In the event of motor overload due to application of excessive pressure to the disc, performance will drop noticeably
or the power tool may stop running (avoid stalling the power tool in this way).
If the power tool has been overloaded, release the pressure applied and then allow it to run under no load for approx.
30 seconds.
3.5 Guard with front cover 2
CAUTION
When grinding with straight grinding discs and cutting with cutting discs in metalworking applications, use the
guard with front cover.
3.6 DC‑EX 125/5"‑C compact dust removal hood for cutting 3
For cutting mineral materials using diamond discs.
CAUTION
Use of this guard for working on metal is not permissible.
3.7 DG-EX 125/5" dust removal hood for grinding 4
The grinding system is suitable only for occasional use with diamond cup wheels for grinding mineral materials.
CAUTION
Use of this guard for working on metal is not permissible.
3.8 Lithium‑ion battery charge status
When the lithium-ion battery is in use, the charge status can be indicated by gently pressing one of the battery release
buttons (press until resistance is felt - do not release the battery). The display on the rear of the battery provides the
following information:
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs flash, please refer to the information given in the Troubleshooting section.

4 Consumables

Discs with a diameter of max. 5", designed for a speed of 11000/min and a peripheral speed of 80 m/sec, and
with a maximum thickness of ¼" (abrasive grinding discs) or ¹⁄₈" (abrasive cutting discs).
Discs / wire brushes
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Wire brushes
LEDs blink
-
-
-
-
LED 1
Application
Cutting, slitting
Cutting, slitting
Rough grinding
Rough grinding
Wire brushes
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Designation
AC‑D
DC‑D
AG‑D, AF‑D, AN‑D
DG‑CW
3CS, 4CS, 3SS, 4SS
Material
metal
mineral
metal
mineral
metal
7
en