Disposal; Manufacturer's Warranty - Tools - Hilti AG 500-A18 Mode D'emploi

Fault
The power tool or the battery
becomes very warm.
en
The power tool doesn't achieve
full power.
No braking function.

10 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: the burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or incinerate the
batteries.
CAUTION
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned
to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.

11 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.
12
Possible cause
Electrical fault.
The power tool has been overloaded
(application limits exceeded).
A battery with inadequate capacity
was used.
The battery is discharged.
The tool is overloaded (application
limits exceeded).
Remedy
Switch the power tool off immedi-
ately, remove the battery from the
tool and allow it to cool down while
keeping an eye on it, contact Hilti
Service.
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
Use a battery with a capacity of at
least 2.6 Ah.
Charge the battery.
Switch the power tool off and on
again.