Controller Unit; Controller View. Explanation Of Buttons And Indicators - Sunsystem BURNit PelleBurn PLB 15 Instructions D'installation Et D'exploitation

EN
- Clean the Auger from the ashes of the transport of
pellets: Dust off (3) and clean the ashes from the
collected (4)
- Mount the feeding auger back to the pellet hopper.
Important! Fill Auger and calibrate
it. If auger remain without fuel for
transportation will deteriorate normal
boiler operation.
9.3.5. Pellet hopper:
- Completely empty the pellet hopper
- Clean the pellet ash residues from the bottom of
the hopper. Use the scraper and a vacuum cleaner.

10. CONTROLLER UNIT

10.1. Controller view. Explanation of buttons and
indicators.
Enter button
When adjustment is enabled, use arrow keys UP
and DOWN
Press ENTER
TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL
Diagram 22
LCD screen:
The controller
displays the information
for the operation of the
facility.
Explanation of buttons:
When logging into a
menu, use arrow keys
UP and DOWN
to move
one page to another.
permits adjustment of the page.
to adjust the parameter.
to change the parameters.
Press F to exit the menu.
Confirm with Enter button
Display symbols explanation:
Auto Clean symbol appears in right upper
part of display. Active auto cleaning symbol
means boiler automatic cleaning mode.
Crossed-out flame symbol appears in upper
right part of display. Means that the boiler
enters into Extinguish mode.
CH priority /Radiator /symbol appears in
upper part of display. Means than Central
Heating priority is set to heat up the central
heating.
Domestic Hot Water /shower/ priority symbol
appears in upper part of display. Means than
DHW priority is set to heat up the domestic
hot water. When set DHW temperature is reached,
DHW pump stops and CH pump is activated.
Parallel pumps /shower and radiator/
symbol appears in upper part of display.
Means that is set equal priority to both
pumps. They work in parallel and are
controlled by temperature sensors.
Summer mode /shower and sun/ symbol
means than is set Summer heating mode.
Only DHW pump is active.
Burner flame symbol appears in upper right
part of display. Means that burner is
activated. Burner goes into Ignition mode
and upcoming boiler fire up.
Flame 2 symbol means Maximum output
mode of boiler. In this mode the boiler
operates at maximum output.
Flame 1 symbol means Low output mode of
boiler. In this mode the boiler operates at
screen
minimum output.
The notice "Hi" appearance on the screen
where the boiler temperature is displayed
means that the measured boiler body
temperature is above 120°C. Flashing and
beeping alarm is activated.
corrected, notification can be deleted. Disconnect
fuel auger from boiler plug-in socket. Upon any such
occurrence please contact immediately your installer
from
for system checkup.
Boiler increased temperature.
symbols appearance on the screen where the
boiler temperature is displayed means that
boiler temperature has increased up to 99°C.
In such a case, please contact immediately to your
installer to check the system.
14
.
When the issue is
Those two