Sunsystem BURNit PelleBurn PLB 15 Instructions D'installation Et D'exploitation page 12

burner is performed by an authorized installer or
service shop.
EN
Failure to observe the installation and
operating requirements described in the
manual and the service booklet voids the
warranty.
9.3. Requirements for the cleaning and maintenance
of PelleBurn pellet boiler with pellet burner.
Attention!
regarding cleaning of boiler.
Caution! Hot surfaces.

Before cleaning the boiler, make sure the
fire in it has died out and the boiler has
cooled down.
- It is mandatory to clean the ashes from the container
once a week. Unhook the buckles on both sides of
ash container. Pull ash container out of the boiler
and clean it. Once you have emptied the container
of ashes, please make sure you close the container
cover tightly, buckle-lock it to the container buckles,
then buckle-lock the container to the boiler buckles.
- It is mandatory to clean once a month the
combustion chamber of the burner.
Attention! Cleaning and maintenance of
the boiler should be carried out only by an
authorised installer/service shop.
Before the start of the heating season it is mandatory
to check and clean the following components of the
boiler:
9.3.1 Cleaning and maintenance of suction fan
TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL
Important instructions
Diagram 13
Diagram 14
- Remove the two parts of the boiler top cover by
lifting them upwards
2
Diagram 15
- Remove the cover of the inner boiler body (2) using
wrench S13.
- Clean the fan blade (1) and the dust and soot
deposits. Use a brush. If the fan is not properly
cleaned, this will affect the boiler performance.
Diagram 16
- Check the nut holding the fan blade (2) to be well
tightened. Attention: the nut is left threaded!
- Upon assembling the gasket of the fan must fit well
in place. If necessary, change the fan gasket.
- Mount back the top cover
9.3.2. Cleaning and maintenance of the cleaning
system:
- Remove the top cover (9.3.1).
- Cleaning system (1). Clean the ash deposits using a
vacuum cleaner and/or a brush.
Diagram 17
- Hold a visual inspection of the condition of the
12
1