Kreg KHI-SLIDE Guide D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ATTENTION
When installing the drawer members of ¾-extension drawer slides with flanges that extend under the
sides of the drawers, turn the drawer upside down on your workbench and install the drawer members, observing
the manufacturer's setback from the front of the drawer.
• Slide the spacers out of the cabinet until
they protrude 4" [102mm], keeping the
remaining length of the spacers under the
drawer slides mounted inside the cabinet.
• Place the drawer box on the spacers with
the front of the box aligned with the ends of
the spacers.
• Extend the drawer slides. Follow the
drawer-slide manufacturer's instructions for
the slide setback distance from the front of
the drawer box.
• Using the holes in the drawer-slide drawer
members as guides, drill pilot holes for
the front screws and screw the slides to the
drawer box.
• Extend the drawer to expose the middle
mounting holes, drill pilot holes and drive
the screws.
• For ¾-extension drawer slides, remove
the drawer from the cabinet. Using the rear
mounting holes as guides, drill pilot holes
and drive the screws.
• For full-extension drawer slides, extend the
drawer all the way. Using the rear mounting
holes as guides, drill pilot holes and drive
the screws.
• Remove the spacers.
• Check the drawer operation and adjust
the position of the drawer box as
necessary by adjusting the position of the
drawer-slide cabinet members. When
satisfied with the fit, use the round holes
in the drawer-slide cabinet members as
guides to drill pilot holes and drive screws
to fix the drawer-box position.
FRAMELESS CABINETS
Spacers extended 4" (102 mm)
8

Publicité

Table des Matières
loading

Table des Matières