Removing A Unit From Storage - stayer GAS CUTTER 33 Instructions D'emploi

= Shaft length.
= Fuel tank capacity.
= Weight.
L = Sound power level.
WA
L = Sound pressure level.
PA
= Vibration.
13 NOISE
Measured values of noise emission in accordance with
the relevant standard. (K=3) Sound pressure level LpA 93
dB (A) sound power level LwA 113 dB (A)
ATTENTION! Use an ear protection if the sound pressure
exceeds 85 dB (A). aw (vibration level): 7.8 m/s
K = 1.5 m/s
14 STORAGE
WARNING: Failure to follow these steps may
cause varnish to form in the carburettor and
lead to difficult starting or permanent damage
after storage.
- Clean outside surface of unit.
- Drain fuel from the fuel tank.
- After fuel is drained, start engine.
- Run engine at idle until unit stops. This will purge the
carburettor of fuel.
- Allow engine to cool (approx. 5 minutes).
- Using a sparking plug wrench, remove the sparking
plug.
- Pour 1 teaspoon of clean 2-cycle oil into the combustion
chamber. Pull starter rope slowly several times to coat
internal components. Replace sparking plug.
- Store unit in a cool, dry place away from any source of
ignition such as an oil burner, water heater, etc.
- Put the sleeve on when not in use or in transportation.

15 REMOVING A UNIT FROM STORAGE

- Remove sparking plug.
- Pull starter rope briskly to clear excess oil from
combustion chamber.
- Clean and gap sparking plug or install a new sparking
plug with proper gap.
- Prepare unit for operation.
- Fill fuel tank with proper fuel / oil mixture. See Fuel and
Lubrication Section.
ENGLISH
26
16 TROUBLE SHOOTING
PROBLEM
Unit won't start or
starts but will not
run.
Unit starts, but
engine has low
power.
Engine sputters.
No power under
load.
Runs erratically.
Smokes excessively.
26
PROBABLE CAUSE CORRECTIVE ACTION
Incorrect starting Follow instructions in the
procedures.
Incorrect carburettor Have carburettor adjusted
mixture adjustment by an Authorized Service
setting.
Fouled sparking plug. Clean/gap or replace plug.
Fill fuel tank with properly
Empty fuel tank.
Primer bulb was not Press primer bulb fully and
pressed enough. slowly 10 times.
Fuel filter is plugged. Replace the fuel filter.
Incorrect lever position. Move to RUN position.
Dirty spark arrester Replace spark arrester
screen.
Remove, clean and reinstall
Dirty air filter.
Incorrect carburettor mixture Have carburettor adjusted
adjustment setting service by an Authorized Service
dealer.
Incorrect carburettor Have carburettor adjusted
mixture adjustment by an Authorized Service
setting.
Air filter is blocked. Replace or clean the air filter.
Old or improperly mixed Drain gas tank/add fresh fuel
fuel.
Incorrect carburettor Have carburettor adjusted
mixture adjustment by an Authorized Service
setting.
Old or improperly mixed Drain gas tank /add fresh
fuel.
Air filter is blocked. Replace or clean the air filter.
Fouled sparking plug. Clean/gap or replace plug.
Incorrectly gapped
Clean/gap or replace plug.
sparking plug.
Clean or replace spark
Blocked spark arrester.
Dirty air filter. Clean or replace air filter.
Incorrect carburettor Have carburettor adjusted
mixture adjustment by an Authorized Service
setting.
Use properly mixed fuel
Incorrect fuel mixture.
User Manual.
Centre.
mixed fuel.
screen.
filter.
Centre.
Centre.
mixture.
Centre.
fuel mixture.
arrester.
Centre.
(40:1 mixture).