Reset the cleaning indicator
When you replace the grease fi lter after clean-
ing, it is suffi cient to press the
seconds to again set the indicator.
If you do not do this the indicator light will continue to fl ash
when switching on the extractor hood.
Accessing the grease fi lter
Take hold of the right and left side of the bottom panel
(A) and pull down simultaneously. Remove the fi lter (B) by
tak ing hold of its hook and pulling down.
Cleaning the grease fi lter
The metal grease fi lter can be cleaned by hand or in a dish-
washer. We recommend cleaning the grease fi lter by hand.
Cleaning the fi lter by hand:
− Immerse the fi lter in a solution of boiling water to which
a degreasing detergent has been added.
− Use a brush for cleaning
− Then rinse the fi lters with warm water under a tap and
allow them to dry.
Cleaning the fi lter in a dishwasher:
− Use a customary dishwasher detergent
− Do not put the saturated grease fi lters together with
crockery in the dishwasher
− Select a programme with a low temperature
− After cleaning allow the fi lter to drain.
When cleaning in a dishwasher the fi lter may
discolour as a result of the salt content. This
does not affect its operation.
Replacing the grease fi lters
− Before replacing the grease fi lter, clean the edges of the
− Grasp the fi lter with 2 hands.
key for 5
2
− Make sure that the lock or the lip on the fi lter is on the
− Insert the back of the fi lter in the opening, press the fi lter
3.4 Led lighting
Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down suffi ciently.
1. Carefully press the spotlight holder; next, remove the
2. Removing the LED spotlight:
A. First disconnect the cable leading to the LED spotlight
B. Then remove the LED spotlight to be replaced by making
C. Remove the LED spotlight to be replaced from the
– 39 –
part in the extractor hood in which the fi lter is placed.
bottom side.
upwards at the front and make sure it clicks tight.
You can obtain a new grease fi lter from a dealer
or the Novy website. Article number grease
fi lter: 6830.020(2x).
spotlight holder by means of a tilting movement.
to be replaced. Disconnecting is done by releasing the
lock by applying a light pressure and pulling it off at
the same time.
a soft rotating movement counterclockwise.
bayonet ring.