Adding Firewood - Jotul F 162 Manuel D'installation Et D'utilisation

4.7 Control of functions
When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Jøtul F 162, F 162 C, F 163 and F 163 C are equipped with the
following control:
Ignition vent/air vent
Ignition
Fig. 7a
• Open the ignition vent and air vent by pulling the handle all
the way out. (Use a glove or something similar to protect your
hand in case the handles are hot.)
• Place two logs at the bottom of the burn chamber and pile
the kindling in layers.
• Finally, place a medium-sized log on the top of the pile.
• Place 2 or 3 briquettes or kindling sticks under the top layer
of kindling and light the fire.
Heating
Fig. 7b
• Leave the ignition-/air vent 40 mm (fig. 7 B) open when the
wood has caught fire properly and is burning well.
• Close the door.
• You can then regulate the rate of combustion to give the heat
you want by adjusting the air vent.
• Check that the afterburning (secondary combustion) starts.
This is best indicated by yellow, flickering flames in front of
the holes under the baffle.

Adding firewood

Stoke the stove frequently but only add small amounts of fuel at
a time. If the stove is filled too full, the heat created may cause
extreme stress in the chimney. Add fuel to the fire in moderation.
Avoid smouldering fires as this produces the most pollution.
The fire is best when it is burning well and the smoke from the
chimney is almost invisible.
4.7 Danger of overheating
The fireplace must never be used in a manner that
causes overheating
Overheating occurs when there is too much fuel and/or too much
air so that too much heat develops. A sure sign of overheating is
when parts of the fireplace glow red. If this happens, reduce the
air vent opening immediately.
Seek professional advice if you suspect that the chimney is not
drawing properly (too much/too little draught). For further
information, see «4.0 Installation» (Chimney and flue pipe).
ENGlish
57