Problems And Troubleshooting - Robland D 630 Mode D'emploi

Problems and troubleshooting

1 The machine does not start when the start button is activated:
- workshop main fuse is switched off: power cut, power shortage, or general overload.
- main switch off: put switch on "1" .
2 Reduction of cutting speed when working:
- belt tension not correct: tension the belt
- motor overload due to incorrect feed rate: reduce the feed rate
- blunt tools: sharpen tools
3 Vibration of the machine:
- worn or damaged belt: replace the belt
- overtensionned belt: loosen belt
4 Thermal overload does not re-arm automatically after shut-off and cooling down period:
- overload is not set on automatic reset, or the overload is faulty: set on automatic, or replace
If you cannot solve the problem yourself or you do not find your problem in this list,
please contact your Robland dealer.
D 630 V1112
Deutsch English Français Nederlands
53