Calibration Of The Digital Read Out - Robland D 630 Mode D'emploi

Calibration of the digital read out

It is highly recommended that each time the planer knives are changed, the digital
read out is calibrated, this to avoid measurement errors.
Calibration is done as follows:
- set the thicknesser table at a random height and thickness a sample.
- now measure exactly the thickness of the sample.
- now the digital read out has to be set at the same measure, and this can be achieved as follows:
press simultaneously the buttons F and SET on the read-out:
Now the read-out begins to count up at 3 progressive speed rates:
- Rate 1: at 1Hz for 10 sec.
- Rate 2: at 10 Hz for 10 sec.
- Rate 3: at 1000 Hz for as long as the 2 buttons F and SET are held.
- Shortly before the desired value is reached, release the two buttons and press the same two buttons
so as to approach the desired value with the slowest rateof 1 Hz.
The thicknessser now is calibrated over the full 300 mm capacity.
To set the read-out at 0, simultaneously press Set and RESET.
IMPORTANT
Before starting to work on the thicknesser always ensure that the anti-kickback protection fingers are
clean and hang down freely in position under their own weight. These anti-kickback fingers should be
inspected on a regular base, and kept clean and free of any resin deposits whatsoever. Ensure the
correct position and locking of the dust chute. Roller supports should be used when long workpieces
are machined. Ensure the ticknesser table is well cleaned, since a smooth table surface is essential
for good operation of the thicknesser.
Fig.6
D 630 V1112
Deutsch English
(Fig.6)
Français Nederlands
49