Thicknesser Feed - Robland D 630 Mode D'emploi

Thicknesser feed

The machine is equipped with an frequency variator thus enabling an feeding speed of 5 to 22 m/min.
The feeding motor is started-up by pushing the button of the potentiometer POT, and by turning the
same button a feeding speed can be selected between 5 and 22 meter per minute, changing over from
one speed to an other can be done without having to stop the feeding motor. In case of overloading of
the feeding mechanism the feeding motor must be disengaged immediately by pushing the button of
the potentiometer POT and the main cutterblock motor by pushing the emergency stop button (fig. 3,
AU1) on the switch panel. After reducing the depth of cut on the thicknesser, the motor can be started
up again.
Fig.7
50
Nederlands Français
Main motor start
Potentiometer feeding speed
Feeding speed reset
in case of overload
Feeding speed frequency
variator warning light
English
(Fig.7)
Emergency stop
Deutsch
V1112 D 630