Adjusting The Depth Of Cut On The Thicknesser - Robland D 630 Mode D'emploi

Safety measures on the thicknesser
- - Check iff the planer knifes are well tighened and secured. When this is not the case the knifes by
the centrifugal force will be ejected from the cutter block.
- It is absolutely essential to read this manual before using the machine so you know how to the
machine works and what its limitations are.
- Always make sure that all safety devices are fitted to the machine and that the machine is connected
to a dust extraction system.
- Always wear suitable clothing, loose or torn clothes are very dangerous.
- Keep children away from the machine and out of the workshop.
- To avoid damaging your hearing we recommend to wear ear protection, when working with the
machine.
- The height of a planer knife must be 20 mm minimum!
Adjusting the depth of cut
on the thicknesser
The raise and fall of the thicknesser table is motor driven at 2 speeds up-and down by pushing the
switch S5 for the rise and fall at fast speed, the button S7 for the slow speed rise and fall.
The position of the thicknesser table can be set at 1/10 mm
Table up fast
Table up slow
Table down fast
Fig.5
48
Nederlands Français
Table down slow
English
(Fig.5)
Position of the table
Deutsch
V1112 D 630