Maintenance - Robland D 630 Mode D'emploi

Optional thicknesser table rolls
Fig.8

Maintenance

Attention:
Always disconnect the machine from its power supply before starting all maintenance works!
The interior parts of the machine must be cleaned regulary in order to avoid an accumulation of dust
and woodchips.
Any possible deposit of resin on the various parts of the machine must be taken away with a piece of
cloth and a little solvent (petrol, kerosine or other product)
Never smoke or have any naked flame near the machine when using inflammable products, this
to prevent risk of fire and serious burns for the operator!
After removing the front, back, and side cover plates, all machine parts which need maintenance are
exposed. The thread bars and posts of the table and the drive chains of both rise and fall of the table
and the feeding mechanism must be cleaned on a monthly base using a thin oil.
The use of a dust extractor system will most certainly extend the life of your machine. The life of the
motors can be extended by blowing out saw dust from the cooling fan and from the motor body itself.
D 630 V1112
As an option the machine can be equipped with 1 or 2
rolls in the table. In order to lower the rolls under the table
simply pull the handle and lower, as indicated on the
pictogram.
Deutsch English
(Fig.8)
Français Nederlands
51