Dust Extraction; Changing And Setting Of The Planer Knives - Robland D 630 Mode D'emploi

Dust extraction

For your own health and to avoid fire risk and dust explosion, it is recommended toconnect the
machine to a dust extraction system. The 160 mm outlet on the dust chute need to be connected to a
dust extractor, powerfull enough to obtain an airflow of at least 20 m/sec., measured at the outlet on
the machine
Changing and setting
of the planer knives
In order to turn the planer arbor by hand, push the brake release switch (fig.3, S4.1) the warning light
L1 will light. Now the dust-safety hood can be opened by pulling the handle situated at the side of
the hood.
To avoid serious injuries when handling planer knives, the wear of safety gloves is highly
recommended: even blunt knives can cause serious damage to your hands!
Make sure both planer knives and jib strips are well cleaned before putting them into the slots in the
planer arbor.
Take care of the springs underneath the knives, and see to it that they do not stay blocked inside their
seats in the arbor.
Now put the cleaned planer knive into the groove, pushing the knive down with the adjustment
gauge(fig.4)), and tighten the bolts. Repeat above for the other planer knives.
Make sure all knives are set at exactly the same height. Before starting up the machine check again
if all bolts are well tightened, and then push the brake release switch (fig.3,S4.1) the warning light L1
must dim.
Fig.4
D 630 V1112
(Fig.4)
Magnetic knife
setter jigs
Deutsch English Français Nederlands
47