How To Solve Errors - GSW System Classic Mode D'emploi

DKT GSW System Classic DE-GB-FR Set Seite 29 Mittwoch, 16. Mai 2018 2:45 14
Warning!
As soon as
emerges, remove the source of heat.
The device is not to be used again until
Error
Steam is escaping from
between the lid and the base
No steam is coming from the
pressure regulator
Too much steam is coming from
the pressure regulator
Steam is escaping laterally
from the pressure regulator
Steam is escaping from the
safety opening
The lid does not open
GSW System Classic

8. How to Solve Errors

the error has been corrected. Only a slight
uncontrolled steam emergence of steam from pressure regulator 6 is
normal.
Cause
Appliance not closed correctly
Sealing ring is dirty
Sealing ring is broken/worn
away
Steam is escaping from
between the lid and the base
Pressure regulator is dirty
Not enough liquid in the
appliance
Heat supply too low
Heat supply too high
Pressure regulator is dirty
The pressure regulator is not
correctly fitted
The pressure regulator is soiled Take the pressure cooker off the
The pressure regulator is
defective
The safety valve is defective
There is too much pressure in
the appliance
Solution
Close the appliance again correctly
Clean the sealing ring
Replace the sealing ring (1 x year)
See previous error
Clean the pressure regulator (see
"7.2 Cleaning the pressure cooker"
on page 26)
Slowly cool down the appliance
and fill with at least 0.25 l fluids
Increase the heat supply (turn the
hob to a higher setting)
Decrease the heat supply (turn the
hob to a lower setting)
Clean the pressure regulator (see
"7.2 Cleaning the pressure cooker"
on page 26)
Fit the pressure regulator correctly.
stove and allow it to cool down.
Then clean the pressure regulator
(see "7.2 Cleaning the pressure
cooker" on page 26)
Exchange the pressure regulator for
a new one
Exchange the safety valve (see
"Service Address:" on page 32).
Follow the instructions in
"6.4 Opening the pressure cooker"
on page 25
29