GE Xcellerex XDUO Quad Single-Use Mode D'emploi page 384

B User interface description
B.2 User interface: dialog boxes
B.2.3 Setpoint managing dialog boxes
Setpoint Table Configuration
The Setpoint Table Configuration dialog box can be accessed by clicking on the Confi-
gure button of a chosen PID control loop in Setpoint Table Screen. This dialog box allows
the user to configure up to twenty separate steps to change the setpoint of the chosen
parameter during a run. It is also possible to set up a loop of setpoints.
Part
1
2
3
4
5
6
7
8
384
1 2 3
6 7
Name
Step Name
Start SP
End SP
Step Duration
Loop Start / Stop
Insert Row / Delete Row
Reset Loop
Apply Changes
4 5
8
Function
The name of the step
The intended setpoint at the start of the step
The intended setpoint at the end of the step
The time length of a step
Enables to set the chosen set of steps to re-
peat
Buttons to insert or delete a row
The button to remove configured step looping
The button to save defined configuration
changes
Xcellerex XDUO Quad Single-Use Mixeur Mode d'emploi 29-0885-07 AA