Fuse Replacement; Declaration Of Conformity (Doc); Disposal - Renkforce 1488542 Mode D'emploi

b) Fuse Replacement
If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see "Technical
Data") as a replacement.
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the POWER mains socket
on the device.
• Using a suitable screwdriver, carefully lever out the fuse holder of the mains connection POWER IN with the
defective fuse.
• Remove the defective fuse and replace it with a new fuse of the indicated type.
• Carefully push the fuse holder with the new fuse back into its position at the mains connection of the device.
• After this, you can reconnect the device to the mains and take it into operation.

15. Declaration of Conformity (DOC)

We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this product complies with the
fundamental requirements and the other relevant regulations of the directive 1999/5/EC.
You can view the conformity declaration for this product at: www.conrad.com

16. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of its service life.
37