Maintenance; Cleaning; Fuse Replacement - Renkforce DL-LED162 Notice D'emploi

11. Maintenance

Regularly check the technical safety of the effect spotlight, e.g. for damage to the mains cable or the
casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately
and make sure it is not operated unintentionally. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• the device no longer works
• the device has been stored under unfavourable conditions for an extended period of time or
• after exposure to extraordinary stress caused by transport
Always observe the following safety instructions before cleaning or servicing the effect spotlight:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work
is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.
a) Cleaning
The outside of the effect light should only be cleaned with a soft, dry or slightly moistened cloth.
Never use any aggressive cleaning agents or chemical solutions as these may damage the surface of the
casing.
b) Fuse replacement
If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see
„Technical Data") as a replacement
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the POWER
mains socket on the device.
• Using a suitable screwdriver, carefully push the fuse holder at the mains connection.
• Remove the defective fuse and replace it with a new fuse of the indicated type.
• Now carefully re-insert in the fuse holder with the new fuse.
• After this, you can reconnect the device to the mains and take it into operation.
35