English
Only connect the high-pressure cleaner
to the drinking water main in conjunction
with a back flow preventer – see "Special
accessories".
WARNING
If drinking water has passed
–
through the back flow preventer, it
can no longer be regarded as
drinking water.
Do not use the machine with dirty water.
If there is a risk that dirty water will occur
(e. g., flowing sand), an appropriate
water filter must be used.
Inspect the high-pressure cleaner
WARNING
The high-pressure cleaner should
–
only be used if it is in full working
order and undamaged – risk of
accident!
It must be possible to move the
–
switch to the 0 position easily
The switch must be in the 0 position
–
Do not use the machine with a
–
damaged high-pressure hose,
spray attachment and safety
devices
High-pressure hose and spray
–
attachment in good condition
(clean, moving easily) and correctly
assembled
For good control of the machine, the
–
handles should be clean and dry
with no oil or dirt on them
Check oil level
–
38
Never attempt to modify the controls
–
or safety devices in any way
Set up the machine so that it cannot
–
slip or tip over. Only operate the
machine on a stable and level
ground
Electrical connection
WARNING
Minimize the risk of electrical shock:
Voltage and frequency of the
–
machine (see rating plate) must
match the voltage and frequency of
the mains supply
Examine the connecting cord,
–
power plug and extension cord for
damage. Do not use the machine
with a damaged connecting cord,
extension cord or damaged power
plug
Only connect the machine to a
–
correctly installed power socket
The insulation on the connecting
–
cord and any extension cord, the
plug and the coupling must be fully
intact
Never touch the power plug,
–
connecting cord and extension
cord, and electrical plug
connections with wet hands
WARNING
Route the connecting cord and
extension cord properly:
Observe the minimum cross-section
–
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
–
that it cannot become damaged and
no one is endangered – risk of
stumbling!
Use of unsuitable extension cords
–
can be dangerous. Use only
extension cords that are approved
for outdoor use and are
correspondingly marked and have a
sufficient cross-section
The connector and coupling of the
–
extension cord must be waterproof
and must not lie in water
It is advisable to keep the plug
–
connection at least 60 mm above
the ground/floor, e. g. by using a
cable reel
Don't let the cord rub against edges
–
or pointed or sharp objects
Don't squeeze the cord under doors
–
or windows
If cords become snarled – unplug
–
the power plug and unsnarl the cord
Always unroll the power cord from
–
the cable reel completely, to avoid
risk of fire due to overheating.
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS