Troubleshooting; Safety Instructions; Causes Of Malfunctions And Their Rectification - Heiniger XPERIENCE Mode D'emploi

7

Troubleshooting

7.1

Safety instructions

DANGER!
DANGER OF FATAL ELECTRIC SHOCK!
Fatal electric shocks can result from contact with electrically live
conductors or components!
Switch the equipment off before troubleshooting the problem.
X X
Repairs to electrical devices must only be carried out by the
X X
factory service department or specialists who have been
trained by the manufacturer.
During the warranty period the device must be opened only by personnel
authorised by the manufacturer, otherwise the warranty will be void.
7.2

Causes of malfunctions and their rectification

Malfunction
Upper blades moving too
little.
Top blade does not move. Defective gear wheel.
Adjusting knob jammed.
Leaf springs in the head
mount are too loose.
Play between pivot lever
and leaf spring.
Pivot lever difficult to
move up and down.
Motor runs very slowly.
16
Cause
Leaf springs broken.
Eccentric square or ec-
centric shaft worn (insuf-
ficient lubrication).
Thread dirty or rusty.
Pressure spring jammed.
Comb plate screws loose. Tighten the comb plate
Leaf springs and/or cylin-
der head
screws worn.
Centring sleeve lost.
Clipper blades were not
oiled sufficiently.
Motor and/or electronics
defective.
Instruction Manual / Xperience 2-Speed cattle clipper
Rectification
Notify customer service.
Notify customer service.
Notify customer service.
screws.
Notify customer service.
Notify customer service.
Lubricate the clipping
blades.
Notify customer service.