Preparation; Connecting The Ac Power Cord - Sony HR Trinitron PVM-20M7MDE Mode D'emploi

Preparation

This section explains preparation required before
attempting to operate the monitor, and how to connect
to other equipment.
For detailed information on connecting the monitor to other
equipment, refer also to the instruction manuals supplied
with those equipment.

Connecting the AC Power Cord

Connect the supplied AC power cord to the ⁄AC IN
connector and to a wall outlet.
To connect an AC power cord securely with the AC plug holder
Before connecting the AC power cord to the ⁄AC IN
connector and to a wall outlet, we recommend to
connect an AC power cord securely with the AC plug
holder as follows .
1
Attached holder
AC plug holder
2
14
Note
Always turn off the power of the monitor and other
equipment before attempting to make connections.
Cautions on power connection
• Use the supplied AC power cord.
• Set the power switch to OFF before connecting or
removing the AC power cord.
• Make sure that the power supply conforms to the
voltage rating in "Specifications" on page 29.
1
Plug the AC power plug into the attached holder.
Then attach the supplied AC plug holder on the top
of the AC power cord.
2
Slide the AC plug holder over the cord until it
connects with the attached holder.
AC power
To disconnect the AC power cord
plug
Note
Wait at least 10 seconds after switching OFF the
power switch before disconnecting the AC power cord
to discharge any static electricity from the CRT
display tube.
Pull out AC plug holder by squeezing the up and down
side.