Preparation Steps - Sony NSBK-DH05 Manuel D'installation

Preparation Steps

Step 1: Installing the Display
Accelerator Board on the NSR-500
(page 6)
Step 2: Connecting the Monitor
(page 9)
Step 3: Configuring Settings for the
NSR-500 Main Unit
Refer to the User's Guide (PDF) for the
NSR-500 series, and configure the
[Monitor] and [Audio] settings in the
[Setup Menu].
Step 4: Verifying Operation
Verify that images are displayed on the
connected monitor.
Installation Complete
6 Preparation Steps / Step 1: Installing the Display Accelerator Board on the NSR-500
r
r
r
r
Step 1: Installing
the Display
Accelerator Board
on the NSR-500
Caution
• Perform installation work in an antistatic
environment.
• Before installing the display accelerator
board, be sure to turn off and unplug the
NSR-500 and wait until the internal
temperature drops.
1
Remove the three screws (B3 × 6
(black)) on the rear panel of the
NSR-500 and the two screws (K3 × 5)
on the side panels, and then remove the
chassis cover in the direction of the
arrow.
Chassis cover
Screw
(K3 × 5)
Screws
(B3 × 6 (black))
Screw
(K3 × 5)