Welding Process - Abicor Binzel TIG ABITIG WH Mode D'emploi

7 Operation
7 Operation

7.1 Welding process

EN - 16
DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
During the welding of workpieces that have been degreased with chlorine-
containing solvents phosgene gas is formed.
• Do not inhale smoke and vapours; prepare sufficient fresh air.
• Clean the workpieces before welding with clean water; do not place any
degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding sparks, glowing work-pieces or hot slag can produce
flames.
• Check work area for fire.
• Make suitable fire extinguishing materials available at the workplace.
• Allow work-pieces to cool down after welding.
• Prior to performing welding work, fasten the ground clamp properly to
the work-piece or the welding table.
WARNING
Arc eye
The arc produced by welding may damage the eyes.
• Wear protective clothing and eye protection.
NOTE
• The welding torch may only be operated by qualified personnel.
• As the TIG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and power supply, must be observed during operation.
• For TIG welding, ensure that all the parameters are set at the power
supply for your welding task.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
®
ABITIG WH